Kenco Wear Supplies

Every time your equipment is down because of worn parts, it’s costing you money. To eliminate that unnecessary downtime, rely on Kenco Wear Supplies, longer wearlife parts for asphalt plants and construction machinery.

Engineered to run longer, Kenco Wear Supplies help you save the cost of new parts, labor, and downtime by minimizing, or even eliminating, future parts replacements.

Asphalt Plants and Paving

Bolt-On Cutting Edges

Four-piece, bolt-on, single-edge blade with 4+1 tungsten carbide (TC) pattern
  • Includes a wide deposit of TC on the leading edge plus a narrow deposit of TC for bolt-hole protection
  • All TC corner guards
Four-piece, reversible, bolt-on, double-edge blade with 6+2 TC pattern
  • Includes wide deposit of TC on both leading edges plus two narrow TC deposits for bolt-hole protection
  • All TC corner guards
Three-piece, bolt-on, single edge blade with 4+1 TC pattern
  • Includes wide deposit of TC on leading edges plus a narrow TC deposit for bolt-hole protection
Three-piece, reversible, bolt-on, double-edge blade with 6+2 TC pattern
  • Includes wide deposit of TC on both leading edges plus two narrow TC deposits for bolt-hole protection

Weld-On Cutting Edges

  • Available in any required thickness and length
  • 3 pass, 5 pass, or special tungsten carbide patterns for extreme service applications

Bucket Moldboards

  • High grade structural steel
  • Special bevel angle leaves more steel in front of bolt holes
  • Oversize moldboard widths are available for extreme applications
  • Custom-built to fit any bucket and bolt-hole pattern
  • Available for general purpose and rock buckets
  • Optional back bevel eases installation

Bucket Lip Assemblies

  • Heavy duty moldboard, with optional bevel TC
  • TC teeth and adapters
  • Weld-on or bolt-on TC blade segments

Tri-Edge Blade Assembly

  • Pre-drilled moldboard
  • Three-piece bolt-on TC cutting edge with single or double-edge blade sections
  • TC side cutters and hardware

4-in-1 Multi-Purpose Buckets

  • Solution for bent or worn 4-in-1 buckets
  • Extra thick, high-strength structural steel moldboard, reinforced with a 1" x 3" structural steel spine to virtually eliminate bent buckets
  • Bolt-on style tungsten carbide cutting edges wipe out expensive, tedious welding when it’s time to replace edges
  • Designs available with or without teeth
  • Available for any bucket width
  • Multi-purpose floors are completely assembled, ready for installation

Kenco Wear Patches

  • 60-63 Rockwell C through-hardened patches available in a variety of flat and curved shapes that install almost anywhere
  • Can be applied up to 14 times faster and outlast hardfacing as much as 10 times longer

Kenco Wear Patch Bucket Lips

  • Made of 3/16" thick steel that is through-hardened to 60-63 Rockwell C
  • One-inch lip set at either 30, 45, or 90 degree angle
  • Easily installed with conventional welding

Kenco Tungsten Carbide Side Cutters

  • Extends bucket corner wear life

Kenco Nut Shields

  • Long-lasting, wear-resistant nut shields protect nuts, prevent loosening, and aid in bucket cleaning
  • Easy to install
  • Available in all standard sizes

Kenco Skid Runners and Bucket Wear Plates

  • Tungsten carbide
  • Available by OEM part number
  • Custom made to any size
  • Bolt-on or weld-on installation